3d printed indoor 18th course ideas

[majin]

whats up homies, its freaking cold outside!!!
so my winter bug is itching like crazy, i can't make it over to the course at the other place so I'm working on another here at the house.
space is KINDA limited, but kinda not??? wtf??
i have a room i can dedicate MOSTLY to the course, but the room is small about 5x5, and it has a water heater in it limiting me a small bit as well.
I'm starting out with just some fun stuff to print cause i like it that way.
I've found a few prints that I'm working on, some boulders and obstacles, I'm going to try to incorporate boxes and plaster paper soon, as for now we just take the plates and throw em down with some other stuff in the floor giving us the whole living room to drive around which is actually pretty awesome but i do like having a more dedicated area i can put more difficult obstacles.
id love any ideas or links to other obstacles if anyone has any,

 

[majin]

 

[majin]

@Doom! I've butchered the bronco lol, decided i liked the bronco body better than the 3d printed body, looking at some tire combos for em hopefully next week i can find a set on clearance. the defender seems to have an issue, may need to look at my driveshaft, it seems to have a binding issue, when trucks powered off it locks up and it drives at half the speed of the other trucks of same size
when you drove it last do you remember if there was a hesitation to i t?

 

[Doom!]

when you drove it last do you remember if there was a hesitation to it?

What have you done!
No issues when I had it, but honestly it didn't have many miles on it.

 

[majin]

What have you done!
No issues when I had it, but honestly it didn't have many miles on it.

you know me brother, i looked at it and that was all she wrote the gremlins appear lol, i do love a good gremlin hunt!! i planned on swapping the motor, and driveshafts out for some nice HD shafts, and gonna throw a roverin in it still, so id say when i swap motors ill look at the gears,