Quick ez start question

[andydrew39219]

I decided to stick with the ez-start on my pede. But, I am going to use a glow ignitor instead of the ez-start ignitor to save on ez start battery and I have read the engines start easier using a separate ignitor.

My question is, can I just pull the blue and yellow prongs out of the harness and then remove the wires or do I have to leave the prongs for some reason? Do I even have to remove them? if the blue wire isn't plugged into the glow plug would it still drain the battery?

 

[mrbones]

There will be no power drain from the wires disconnected. You don't have to fool with disconnecting the yellow wire either.

 

[Zdragon71]

Just pull blue wire back out of way and zip tie it to others. The yellow wire is just a ground for blue ignitor wire so as said above you dont even have to remove yellow wire unkess you just want to. Only wires you need connected are black and red to ezstart motor.

 

[Childresshunt]

I just took a pair of wire snips and cut mine off as close as i could bc i wont ever use it again i like my ignitor

 

[andydrew39219]

I just took a pair of wire snips and cut mine off as close as i could bc i wont ever use it again i like my ignitor

This is what I did.

Thanks for the answers guys. I appreciate it!

 

[Mn Monster]

I just took a pair of wire snips and cut mine off as close as i could bc i wont ever use it again i like my ignitor

same here nice clean look without them !

 

[Childresshunt]

exactly and plus you dont have the worry of it coming loose while running and getting caught up in clutch bell and spur