problem with new hyper 7

[bigjohn]

hi all just got my new hyper 7 a couple of days ago and no problems apart from getting wd40 on my brakes and now is not braking well, any way the problem happened today i started it up no problem run it down the road then it stalled, went to start it again but the servo opens up the carb to full this now happens every time i turn the on tried adjusting the trim and r and n settings on the tx but not working help please thanks john

 

[NCNitro]

Sounds like a linkage issue, or your servo horn is not on the servo properly. Pull the horn off, let the servo center, then make sure the carb is closed and reattach the horn. If you got a horn that has the small adapters for different brand servos you may have used the wrong adapter and it jumped teeth. Or you just might have the wrong horn all together.

 

[bigjohn]

Sounds like a linkage issue, or your servo horn is not on the servo properly. Pull the horn off, let the servo center, then make sure the carb is closed and reattach the horn. If you got a horn that has the small adapters for different brand servos you may have used the wrong adapter and it jumped teeth. Or you just might have the wrong horn all together.

the car is 2 days old and was working now the servo has a mind of its own

 

[Scrogg]

Either the servo went bad or the insert in the horn stripped.
RTR vehicles come with cheap electronics.

 

[Rolex]

#1...Check or replace ALL your batteries. Cheap batteries go very quickly and will cause malfunctions in the signals. Replace them with good ones, or rechargeables.