New problem.

[Alexander_0_1]

So I'm out bashing and start to notice one of my savages bogging when I go WOT, I pulled off the fuel tubing running from the pipe to the tank and it seemed to run way better, any suggestions guys

 

[davidac49]

Sounds like its too rich. Try leaning out the HSN.

 

[Alexander_0_1]

Now that I checking my HSN is loose, must have vibrated itself loose over the afternoon

 

[Zdragon71]

Check the oring seals on the hsn needle. May need to get new ones and replace all the orings on the carb. When they get worn out it causes the needles to vibrate out and richen the carb.

 

[Alexander_0_1]

Still same problem, I changed the pipe from my JP-3 combo to my ofna 086 combo and tightened up the carb....seems as though my axial .32 wants to run better without the tubing that runs from the tank to the pipe.....could my needles be worn out?

Not having this problem with my freshly unboxed picco/boost .28...not at all!

 

[synnyzter]

Still sounds too rich... reset needles and start over?

Sent from my SCH-I500 using Tapatalk 2

---------- Post added at 8:33 PM ---------- Previous post was at 8:32 PM ----------

Could be Carb needles, I've damaged needles in the past on accident

Sent from my SCH-I500 using Tapatalk 2

 

[Alexander_0_1]

You were right, I leaned out, and adjusted my idle gap.....everything's all better

 

[synnyzter]

You were right, I leaned out, and adjusted my idle gap.....everything's all better

Right on! Now go break something!

Sent from my SCH-I500 using Tapatalk 2

 

[RedDot]

Right on! Now go break something!

Sent from my SCH-I500 using Tapatalk 2

Omg this sound like me, i have been already 3 days ridding my rc without braking something hahahaha, at the begining i always have something to fix and spend money on! Did i was the only one? Or its same to everybody

 

[avelciario]

If I am bashing my Savage X I'll try to bash hard until I broke some parts, cause as Savage owner"s says you don't bash in a hard way until you broke something cause we know savage is a tough rig. Almost savage owner do this but always failed to broke something even they bash too hard.

 

[BIRDMAN]

If I am bashing my Savage X I'll try to bash hard until I broke some parts, cause as Savage owner"s says you don't bash in a hard way until you broke something cause we know savage is a tough rig. Almost savage owner do this but always failed to broke something even they bash too hard.

it sure is a tough rig!!

just installed some new big bore aluminum HPI shocks yesterday morning, took it for a test run at a local BMX track and wash bashing hard! nothing broken.