Neptune 3 Pro will not pause.

[ThatGuyDad]

Hello, I've forgone the introduction thread. I'm in to RC, no,il i was into it. I still like it I don't do it enough to call myself anything but an admirer. I am excited to see a forum for printers.

As I mentioned in my title. I have a N3Pro, I'm using Prusa slicer and it's offering me the option to insert a pause but the printer does not honor the pause. I went looking around on line and I found another thread where someone said that it doesn't honor the 600 code, but that post didn't have any replies. Then I'm struggling to find anything else about it. I seen a Neptune 3 post here so I joined up to see if you guys could help me.

I downloaded the Elegoo slicer, opened it and was immediately lost. Compared to the prusa slicer I didn't see any similarities. If I have to learn that slicer in order to achieve this goal I will but I was also hoping that maybe there was another way.

 

[Guest D]

Do you have the option on the printer screen?

I have the centauri so a little different. But try it on the printer.

 

[ThatGuyDad]

Thanks for the reply but no I can pause it fine from the screen. It's timing that's the issue. With the pause command in the slice it stops at the layer I need and should do it if I'm watching or not. At work I have a Prusa unit and this feature allows me to embed things in my prints. Magnets, nuts, bearings etc. This just makes it simple and easy without the need to hover.