Need help please :)

[Mugenseikiboy]

Hi. I was wondering if some of you guys could help me out on a little problem.
I recently got myself a mugen-seiki msx3 1/10 nitro car. It worked fine for the first dozen or so tankfulls, but now a problem has arisen. When the fuel level gets just below the halfway point, the car starts to almost 'choke' itself out when i put on the acceleration. It just gets slower and slower the more acceleration i put on. However, this may occur only 1 out of every 3 times i accelerate. The car finally quits.
After about 20 mins I can restart the car on a half tank of fuel and it runs perfectly until the fuel is all gone. Your thoughts please???

Thanks, Kyle. (I'm a newbie to rc racing)

 

[SilentGTboy]

Your needles are set too lean, please refer to this

https://www.rcnitrotalk.com/forum/showthread.php?s=&threadid=6345

 

[Mugenseikiboy]

Thanks man. I thought it must be some needle that needs turning, but i didnt want to go messing up my engine by turning the wrong thing.

 

[tkhoo]

u can try to rich up the HSN and LSN than u can start tume from HSN to LSN. Last set the ideling. When u lean up every needle pls make sure you check the temp :redbuggy: