Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
The one connected to my throttle servo right?Adjust your linkages.
Do not touch the carb slide idle screw
Do you have the instruction manual?The one connected to my throttle servo right?
Yes I have the manual the nitro scene is new to me I been into the electric rcs more this is my first nitroDo you have the instruction manual?
theres a detailed section on this issue
I haven't seen much on the linkage more so on the idle screw, low speed and high speed needlesYes I have the manual the nitro scene is new to me I been into the electric rcs more this is my first nitro
Dont go turning needles worst thing to doYes I have the manual the nitro scene is new to me I been into the electric rcs more this is my first nitro
I haven't seen much on the linkage more so on the idle screw, low speed and high speed needles
Yes I have the manual the nitro scene is new to me I been into the electric rcs more this is my first nitro
I haven't seen much on the linkage more so on the idle screw, low speed and high speed needles
Ok so look for a little duel coming out the exhaust?Check temps, make sure idle gap is correct. It's always going to idle higher when the tank is less full as it leans out with less tank pressure. If you're not seeing some fuel coming out of the exhaust when idling during break in, you're probably a little lean.
FuelOk so look for a little duel coming out the exhaust?
How do I know what the correct idle gap is I looked yesterday it was kinda small like the point of a penCheck temps, make sure idle gap is correct. It's always going to idle higher when the tank is less full as it leans out with less tank pressure. If you're not seeing some fuel coming out of the exhaust when idling during break in, you're probably a little lean.
How do I know what the correct idle gap is I looked yesterday it was kinda small like the point of a pen