More upgrading!

[theant]

I just ordered the Golden Horizon's front blue anodized bulkhead. It looks pretty sweet! I like Gh parts but i originally wanted to order the flm bulk but my lhs told me that trying to get flm where we are here would take forever. So i tried to get the Strc bulk and again they told me that the Strc bulks are on backorder for months. So i decided to just go with the gh. I'm not sure how i feel about the bulk coming in two pieces but I'm sure it will work great all the same.

I also repainted the body just for fun. I was getting tired of the orange coloring.

Sent from my iPhone using Tapatalk

 

[theant]

Sent from my iPhone using Tapatalk

 

[Greywolf74]

I imagine it will work ok but I'm with you. the fact that is 2 pieces does seem a little odd to me. I got a bulkhead from Dynamite. I like it a lot.

 

[theant]

And there is no reason that i can see why they would do it that way either. Any which way i look at it is that it will be much better than stock. As long as its not integy!


Sent from my iPhone using Tapatalk

 

[theant]

A quick update:



I finally got my Gh front bulkhead in along with a few other parts.

I ended up having to disassemble the whole front end....was thinking it would just slide into place. Keep dreaming right? This is RC after all! The Gh bulk is really nice i have to say. I was a bit skeptical about it coming in 2 pieces but i found out that the top half that attaches to the chassis has 2 small humps that fit into opposing wholes on the bottom half. So it still makes for a super solid bulkhead.

I also went ahead and installed a 6 inch futaba J servo extension and hid the servo wire under the battery. I dremelled a hole in the bottom of the esc mounting plate to feed the extension wire through. I also made the esc screw hold downs larger and used a larger hex screw to hold down the esc. Only reason i did that is cus i HATE philips head screws...with a passion!

Sent from my iPhone using Tapatalk


Sent from my iPhone using Tapatalk