Modded Mini Inferno!

[mnm]

Specs:
Alloy front shock tower
SGG graphite rear shock tower
SSG Graphite steering saver plate
SGG Graphite steering servo plate
Complete set of ceramic ball bearings
Alloy oil filled shocks
Titanium differential joints all around
Rear alloy wing mount
Alloy hub adaptor
Alloy rear chassis brace stiffener
Alloy Steering package (ball bearing)
Alloy rear/front CVDS (Swing Shaft)
Alloy motor mount
Alloy motor heat sink
Alloy steering block
Alloy center deferential hub
Steal slipper gear
Hitec HS-85MG Metal Gear Micro Ball Bearing HS/HT Servo
Quark Pro-car 33AMP ESC (Mamba 6800 Motor) (13 Tooth Metal Gear)
1500mAh 4 Cell 14.8V Lithium Polymer Setup

This rig rips the ground like no other mini i have had, gone through 3 sets of tires in a period of 1-2 weeks. Its really a stable little thing, thats what i like most about it. Other 1/18's i used to have would swerve like a dog chasing a cat at high speeds.


Images:

What happens to a new set of tires after a 10 min run on the road

Enjoy! comments welcomed

 

[RushRC]

You need new tires

Looks very nice, good job! Did you lock the center diff?

 

[mnm]

the center geared deff is not locked.

 

[sweetdiesel]

4s lipo in a mini?!?! I'm surprised the tires lasted 10 minutes. Nice job on the build.

 

[raaazzzeee]

sweet mini!

 

[farace90]

nice mods, is that really stable on WOT. i've bad experience when buying 1/20 MT before. it can't run stable in WOT, always body roll, can't go straight. how fast this mini inferno? thx