gnatsum69
RC Newbie
- Messages
- 6
- Reaction score
- 0
- RC Driving Style
Hey there all,
Just got my lst2. Seems to start good but when cold will just sit there and rev like being in netural. have checked linkage etc and that is fine the lever is hard against tranny case. If i push the truck with my foot it seems to grab gear and go but only for a second or to then just sits there and revs again if i push it about 10 times it finally seems to grab gear and will race around fine for the rest of the tank. One other thing when it does fall out of gear the engine revs get quite high even when i pull back on the brake. it's not that the carby is still open the slide is fully back and it still revs high someone said it could have an air leak into the motor from somewhere. The last time i started it with the roto starter engine woudn't turn over then it would grab and turn a couple of times did that a few times then finally seemed to turn it over and then started. please help sorry to write so much.
Michael
Just got my lst2. Seems to start good but when cold will just sit there and rev like being in netural. have checked linkage etc and that is fine the lever is hard against tranny case. If i push the truck with my foot it seems to grab gear and go but only for a second or to then just sits there and revs again if i push it about 10 times it finally seems to grab gear and will race around fine for the rest of the tank. One other thing when it does fall out of gear the engine revs get quite high even when i pull back on the brake. it's not that the carby is still open the slide is fully back and it still revs high someone said it could have an air leak into the motor from somewhere. The last time i started it with the roto starter engine woudn't turn over then it would grab and turn a couple of times did that a few times then finally seemed to turn it over and then started. please help sorry to write so much.
Michael