losi ten t

[braman]

I'm pretty new when it comes to knowing what parts buy in order to get the vehicle running.. the ten t i bought, the engine fires up but when i engage the throttle, the links move back and forth but it wont run.. please help!!!:\

 

[MudSlinger33]

Does the engine rev up but the car not move? If that's the case then you will need to check the clutch shoes. It would help if you gave more detailed information or even a video showing your problem.

 

[braman]

i had clutch shoe and spring set put in yesterday and it was running for a minute.. then today, no go.. i will try and send a video

 

[Pope]

Check flywheel nut.

 

[braman]

ten t

Check flywheel nut.

what am i looking for?

 

[MudSlinger33]

Remove the clutch bell and there will be a nut that secures the flywheel onto a brass collet. Make sure the nut is tight.

 

[braman]

Remove the clutch bell and there will be a nut that secures the flywheel onto a brass collet. Make sure the nut is tight.

ok i will give it a try.. thank you!

 

[Metalhead Matt]

Make sure the slipper clutch is tight as well. That's on the big gear that the clutch bell contacts.

 

[braman]

both flywheel nut and slipper clutch are tight and no go.. could it be my lead glow plug wire or anything else?

 

[MudSlinger33]

I don't believe the ten-t has a slipper clutch, the center diff acts as the slipper.

---------- Post added at 12:24 PM ---------- Previous post was at 12:18 PM ----------

Also, have you checked the entire drive line for loose or missing screws. Sometimes the set screws that secure the cup joints onto the diffs can rattle loose.

 

[Pope]

Or the pin on one of the planetary gears in the center diff has broken. Or the center diff is blown.

 

[braman]

thanks guys, everything is working now! i got a new glow lead glow plug wire and adjusted the throttle link.. now she's kickin it

 

[MudSlinger33]

Good to hear.