• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

LOSI 8IGHT T RTR .28 revving high when started?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Messages
1
Reaction score
0
Points
1
When I was breaking in my car, I ran it once then let it cool down, upon starting it again with no changes, the wheels spun and the engine revved high, what could the possible problem be?
Idle gap was set correctly, and no other changes were made upon starting my vehicle again.
Any help will be appreciated.
Thanks, -Dripstopher Columbus
 
When I was breaking in my car, I ran it once then let it cool down, upon starting it again with no changes, the wheels spun and the engine revved high, what could the possible problem be?
Idle gap was set correctly, and no other changes were made upon starting my vehicle again.
Any help will be appreciated.
Thanks, -Dripstopher Columbus

Always make sure that the idle gap remains in the same spot when your radio gear is on!
If it changes position when the radio is turned on ,then it is probably just in the servo adjustment
trim on the transmitter!
If that checks out good ,then it maybe that the carb needles out of adjustment or an air leak
somewhere causing it to run lean!
It is hard to diagnose your issue ,with out hearing it or seeing it!...:cool:
 
Back
Top