Jato 3.3 Problem

[robo2207]

Hey guys I'm new here and have a problem with my jato 3.3, its starts fine but when i try to throttle it just revs and dont go anywhere´.. when i throttle i can also see that the bars where the wheels are on move BUT the wheels DONT move WTF Hope you can help me guys :\ Have a good day

 

[tmaxxfreek]

Sounds like your wheel hexes are striped or maybe the adapters arent even on it, take the wheels off and check everything

Sent from my DROIDX using Tapatalk 2

 

[Grave]

+1 on what tmaxxfreak say's also check your clutch for slippage as well you clutch

 

[tmaxxman58]

i melt my plastic hexs all the time. or you could have killed the hexes on the rims

 

[robo2207]

Hey guys thx for answer i was looking at the wheels and wheel hexes and they look just fine .. I just started it up and i can see that sometimes only one of the "Wheelbars" are moving when i try to throttle.. I think it could be the differentiale.. Can you somehow test the differentiale to see its working properly

 

[hamz9561]

Turn one wheel by hand. The other wheel should turn in the opposite direction.

 

[robo2207]

Turn one wheel by hand. The other wheel should turn in the opposite direction.

alright it goes the same way.. What does that mean

 

[robo2207]

Ahh sry its working correctly then.. But what can it be then ??

 

[Greywolf74]

I would take the diff apart and inspect everything inside it. basically just start at your wheels which you did by checking the hexs etc and work your way back down the drive train all the way back to the motor till you come across something that broke, missing, or doesn't look right.

 

[SchrodeMode]

Make sure that the pin is locked behind the hex, I've seen them fall out without being noticed.