I've been looking...

[powerbar]

I've been seachjng for a servo saver for a quarter sqale servo with no luck yet,wondering if they make one. this is a hitec hs-805bb , output shaft is 10mm thick and has 15 teeth. it's for a boat project i;m working on . any help would be appreciated. thanks

 

[RedTarget]

Found this one: http://www.e-clec-tech.com/sesadenun.html

Not familiar with quarter scale, but this says it works with all...

 

[powerbar]

thanks red target

at lease i know they make one, i spent a lot of time looking for one. i tried to place an order for a couple of them through your link but that site only accepts check or money order, no paypal or credit cards ??? too bad the discription did not supply a part #. ohh well...i'll keep looking

 

[RedTarget]

Sorry about that. I really didn't check the site out much, but stumbled upon the servo saver. I'll see if I can find a good one.

Edit: Looks like I may have found something a little bit more legit.

http://www.rcplanet.com/Large_Scale_Servo_s/423.htm

 

[powerbar]

thanks again red target

i also called my not so close lhs but was instructed to call back tomorow while there techs are there, so i'll let you know . tks