cbaker65
RCTalk VIP
I want to install my Fast Eddy bearings ,but I'm in a kind of delimma!
I have had & been using these aluminum knuckles because the originals keep breaking
at the horn on heavy bashing ,but they eat the bearings up ,I had already went through
2 sets of bearings both fronts an rears!
I can't figure out why ,the bearing fit nice an tight an have to be pressed in.
Does any body think that the fitment of the bearing maybe too tight messing up the bearings?
I see other people using aluminum carriers an they don't seem to have that issue!
Heres a pic.
I have had & been using these aluminum knuckles because the originals keep breaking
at the horn on heavy bashing ,but they eat the bearings up ,I had already went through
2 sets of bearings both fronts an rears!
I can't figure out why ,the bearing fit nice an tight an have to be pressed in.
Does any body think that the fitment of the bearing maybe too tight messing up the bearings?
I see other people using aluminum carriers an they don't seem to have that issue!
Heres a pic.