I'm having some problems with me servos

[micahalfred]

I have a CEN Magnum NX truggy and having some problems with my trottle servo and steering servo.....whenever i turn on the power on both the radio and reciever the wheels on the truck automatically turns to the left......could someone tell me what is the problem plz................Also when i press accelerate on the radio the the trottle servo sticks in that position eventhough i realise it....the only way it would realise is if i press brakes.....could someone tell me what is the problem and how to fix them

 

[Metalhead Matt]

Sounds to me as if the throttle servo is over-extending the linkage. Adjust as needed. The steering sounds out of adjustment too. Unhook the steering from the servo and see if the servo turns both ways. If it does, center the servo trim on the radio. Then reattach the steering to the servo with the tires pointed as straight as possible. Fine tune the steering once you get the vehicle moving. The throttle linkage may be able to be adjusted with the trim on the remote. Back it off a little(turn to the left) and see if the throttle quits sticking. Make sure to peek into the carb to make sure it is opening all the way and that your brakes still work. Make sure it returns to the idle position as well.

 

[micahalfred]

No its not turning both ways....I installed a new servo and its doing the same thing

 

[robmob]

What radio setup are you using?