i had anew hyper

[daz1305]

please could someone help I've got a hyper 7 21 3 port black edition and I'm still running it in so well I've just took it out for a spin to finish of running in and my hyper started ok run ok took off ok which i was only going slow as it says in the book and i just turned the car to come back and it just stopped so i tried starting it agaian and it would not go so i changed the glow plug and it still would'nt go so i took the glow plug out and blipped the pull cord just a little and this metal thing come out of the piston it looks like a bronzy copper deposit so i put the glow plug in slightly and come home has anyone had any problems like this with one of these models please help and some advice PLEASE?????

 

[mxracer]

It came out of the piston????:whhooo: Or did it come out of the glow plug hole?? Is it the glow plug gasket????:\

 

[Rolex]

Did it look anything like this?

 

[daz1305]

hello mate the fragments came out of the glow plug hole thnx for the reply (mx racer)

 

[daz1305]

it came out of the glow plug hole mxracer

.....lol...... just little fragments of metal mate thnx rolex

 

[nitro_desert]

its the mesh for the glow plug...so when you put the glow plug it wont tighten right? it keeps falling off ?

 

[daz1305]

i had a new hyper

to all ppl who sent me a reply thnx for all the knowledge and I've sent it off to cml and maybe getting a brand new engine but i am very curios of why these fragments of metal in the engine and could this be a problem for the hyper 7 21 3 port turbo if there is a manufacturing fault on these engines and i will ask these people wot could have done this because I've done everything by the book to THE LETTER and if anyone out there as had the same problem as me please let me know i will keep everyone posted on this thanks ppl

 

[slayer99]

Did u strip the hole out when you where tightening up the glow plug or maybe cross threaded it, which will also result in stripping. I think that is what every one else seems to be asking.onder2:

 

[daz1305]

i had a new hyper

Did u strip the hole out when you where tightening up the glow plug or maybe cross threaded it, which will also result in stripping. I think that is what every one else seems to be asking.onder2:

hi there mate I've took my car back to the shop and it sounds like the bearings casement behind the con-rod has shattered for some unknown reason only i was only runnig it in and i was only on the 8th fuel tank and i only started the car up it ran perfect then i drove it a few feet away from me and just turned the car to bring it back it cut out and then just as i took the glow plug out i always check for the element anyway and I'm still waiting of the outcome to see what as realy gone wrong with my car as i am getting of not knowing what went wrong so i am realy gutted and but my fingers are twitchin to get my car back but I've goto start from the start again but not bothered thats the enjoyment of havin a rc car so ill let everyone now WHY it went the way it did see you l8rs