Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
hi I have a hsp camper and it is just reving high and the wheels keep spinning its not the idle screws fault I closed it so much that the car shut off when i start it up again the wheels just keep on spinning and thoughts
just to confirm, your throttle trim is set correct as well as the idle screw?
high idle is typically from too lean of a LSN, to wide of an idle gap, or an air leak.
i would start re-tuning to factory settings, or at least the LSN back to factory, with a 1mm gap (will need to be reduced after tuning the LSN) and go from there.
how old is the car? maybe swap out fuel lines as preventative measure.
if possible try taking a pic of the engine, i am going to assume its an SH18, but i dont want to say that and it be a VX18.
should say on the side of the engine, if not on the top.
Tried these settings but it isn't starting i found out that when my lsn is closed that much the fuel doesn't go through to the carbFactory settings from what i could find, show the LSN being 2.5 turns from closed, HSN 3.5 turns from closed.
one of the forums i was reading was saying that the LSN can be screwed in too far, and will drop out into the carb. watch for this and keep an eye on it. maybe start with flush instead?
or even from where it is now, back it off 1 full turn. and go from there.