HPi bullet G3.0 a good carburettor base setting for braking in.

[Kyoshohouse]

Does anybody know a standard carburettor setting.

 

[cbaker65]

Does anybody know a standard carburettor setting.

If it is new ,it should be factory set for break in ,but most are usually 1 turn in from flush on the
HSN. ,you would know when the exhaust is dripping on a rich setting!..

 

[Kyoshohouse]

If it is new ,it should be factory set for break in ,but most are usually 1 turn in from flush on the
HSN. ,you would know when the exhaust is dripping on a rich setting!..

If it is new ,it should be factory set for break in ,but most are usually 1 turn in from flush on the
HSN. ,you would know when the exhaust is dripping on a rich setting!..

 

[Maximum_Quake_Pro.com]

Dont go and turn all needles in if your the only owner.

Worst thing to do

 

[Kyoshohouse]

Dont go and turn all needles in if your the only owner.

Worst thing to do

No I just bought a engine it was second hand it looks new though but the needles were already tampered with thats why i want to reset them and run it in properly It has alot of pinch at TDC just like a new engine so i am gathering its not been run . Thanks for your info

 

[Maximum_Quake_Pro.com]

No I just bought a engine it was second hand it looks new though but the needles were already tampered with thats why i want to reset them and run it in properly It has alot of pinch at TDC just like a new engine so i am gathering its not been run . Thanks for your info

Oh thanks for clarifying.

Best of luck with it

 

[GPdori740]

Flush on all needles.