HPi bullet G3.0 a good carburettor base setting for braking in.

Welcome to RCTalk

Come join other RC enthusiasts! You'll be able to discuss, share and private message with other members of our community.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Kyoshohouse

RCTalk Basher
Messages
54
Reaction score
25
Location
Uk 🇬🇧
RC Driving Style
  1. Bashing
  2. Racing
Does anybody know a standard carburettor setting.
 
If it is new ,it should be factory set for break in ,but most are usually 1 turn in from flush on the
HSN. ,you would know when the exhaust is dripping on a rich setting!..👍
If it is new ,it should be factory set for break in ,but most are usually 1 turn in from flush on the
HSN. ,you would know when the exhaust is dripping on a rich setting!..👍
 
Dont go and turn all needles in if your the only owner.

Worst thing to do
 
Dont go and turn all needles in if your the only owner.

Worst thing to do
No I just bought a engine it was second hand it looks new though but the needles were already tampered with thats why i want to reset them and run it in properly It has alot of pinch at TDC just like a new engine so i am gathering its not been run . Thanks for your info
 
No I just bought a engine it was second hand it looks new though but the needles were already tampered with thats why i want to reset them and run it in properly It has alot of pinch at TDC just like a new engine so i am gathering its not been run . Thanks for your info
Oh thanks for clarifying.

Best of luck with it
 

Similar threads

E
Replies
1
Views
942
cbaker65
cbaker65
R
Replies
3
Views
735
Greywolf74
Greywolf74
E
Replies
1
Views
830
Chubaka
Chubaka
jasong83
Replies
7
Views
445
J’sCrawler
J’sCrawler
Back
Top