Hobbywing EZRun Max10 G2 140A ESC

[RustyUs]

You can find all the details about the G2 speed controls HERE. One of the great improvements to the EZRun line up of speed controls is that they have ability to run sensored motors.

Programable Items:

The whole reason I started this thread is because of the LVC default setting is Auto (medium). The medium setting is 3.1v/cell. This can/will lead to LiPo battery cell voltages "dipping" below what I consider safe levels while under load. I try not to let cells go lower than 3v.

 

[RustyUs]

Does anyone have/use Hobbywing's OTA (Over-The-Air) programming device on their Max10 G2 speed control to look at data logs?

 

[Lostinthewoods86]

Not on the max 10, but yes on the max 8 that comes with Bluetooth. Have only used the program box to pull data on the 10

 

[RustyUs]

No Data Log Info

Not on the max 10, but yes on the max 8 that comes with Bluetooth. Have only used the program box to pull data on the 10

Yeah, I have no problem pulling the data logging information from a Max8 G2 using the HW Link V2 app like shown in pic below.

It's getting the same type of info/graphs (like above), from the Max10 G2 140A speed control, that is the problem. Someone else (Josh) on Hobbywing FB group had same problem. I started to comment in Josh's post and when I went to hit the enter/comment button.... the post was taken down. I was able to capture some of the post...

So, it's not just me that has this data logging retrieving issue. I can retrieve a file from the ESC, but when I go to open it, all I get is... 'no data' message that pops up.

 

[RustyUs]

I ran my truck with the OTA Programmer connect to ESC during a few runs and didn't do anything to record data.

I updated ESC firmware, then reverted back to older version of ESC firmware.
I uninstalled/reinstalled HW Link v2 app.
Same outcome... no run data (other than peak motor/ESC heat/RPMs) to view