Help

[jay1603]

Hi I'm totally new to nitro rc cars, iv just brought a hobao hyper 7, iv run the car in as i was supposed to but can any1 tell me how my car is supposed to perform and sound, iv read the manual but dnt understand...... also iv brought a didgital control and my horn is out of sink on the servo how do i reset this thanks

 

[icunvmytmaxx]

Hi I'm totally new to nitro rc cars, iv just brought a hobao hyper 7, iv run the car in as i was supposed to but can any1 tell me how my car is supposed to perform and sound, iv read the manual but dnt understand...... also iv brought a didgital control and my horn is out of sink on the servo how do i reset this thanks

I'm not too sure about your ride, but you can try this. Take your servo horn off the servo. Turn the throttle trim on your tx to 0. Then, turn on your tx then rx. This should center your servo. Put the horn back on and fix your linkage as recommended. hope this helps.

 

[jay1603]

I'm not too sure about your ride, but you can try this. Take your servo horn off the servo. Turn the throttle trim on your tx to 0. Then, turn on your tx then rx. This should center your servo. Put the horn back on and fix your linkage as recommended. hope this helps.

Thanks all sorted now............