Help with Injora SCX24 Controller

[Jake212421]

Bottom left makes the wheel control the car going forward and backward. So if it at 0 the trigger is supposed to control it. While the right knob, if it is at 100, controls the steering with the trigger. So if it is at 0 the wheel is supposed to do the steering

 

[Jake212421]

Does anybody have snap so i can just send a video?

 

[Doom!]

The bottom two knobs are adjustable in case you are a beginner, you can then reduce the throttle and steering until you build up confidence. They should not be set to zero.

 

[Jake212421]

do you have snap? I can just send a video?

 

[Mrgoodwrench35]

You can post a video to YouTube and then a link to the video here. I dont know what snap is.

 

[Jake212421]

okay, i’ll try.

 

[Burnzone]

I know it sounds dumb, but voice of experience speaking here you got steering in channel 1 and ESC in channel 2 vs channels 5 & 6? And they're oriented correctly? Like yellow signal wire is in the up or down position as required? Just sounds like a weird deal. Gotta be something simple though, right?

 

[TeknoJ]

Bottom left makes the wheel control the car going forward and backward. So if it at 0 the trigger is supposed to control it. While the right knob, if it is at 100, controls the steering with the trigger. So if it is at 0 the wheel is supposed to do the steering

You are plugged into your rx wrong. 1 to turn 2 to burn is the old saying.
Those trims are not supposed to be at 0

 

[Jake212421]

You are plugged into your rx wrong. 1 to turn 2 to burn is the old saying.
Those trims are not supposed to be at 0

You were right, wired wrong. Thank you very much!!

 

[Jake212421]

Now i need help again so i bought the 4mm clearing links and now my axle tilts back. anybody got anything?

 

[TeknoJ]

The upper link is too short. What does the other axle look like?

 

[Jake212421]

these are on the rear. Do you think I should swap some? or do you think i should buy new ones?

 

[Jake212421]

 

[TeknoJ]

The upper links on front should be in the back. I think you have the upper links swapped.

 

[Jake212421]

Okay, thank you. I’ll try it and see how it goes

 

[Jake212421]

this is the rear with them swapped

 

[Burnzone]

A chart I found online. Looks like you're dealing with a C10/JLU/Bronco version. The chart recommends front upper 39, front lower 50, rear upper 51, rear lower 58.5. Hook it up that way and see what that does for you. Also post #30 looks maybe hooked up right, but wrong links in wrong places. Post #33 & #36 doesn't look hooked up right to me. Bottom links go on bottom skid plate. Upper links go on upper skid plate

 

[Burnzone]

Like this(a pic from my scx24 based comp crawler)

 

[Jake212421]

So i put them in according to the chart. Now my drive shafts are binding up. Wha should i do?

 

[Burnzone]

If they're binding up, something's not right yet. I assume the links are correct on the skid plate? Without seeing it better at different angles it's a little hard to say what's going on