Help please

[nodsterr]

Hi there,

I just wired up my servo a s6070. Using a DX3C radio.

When i turn everything on it constantly turns to the right and makes a buzzing noise, also heats up a bit. I adjust the trim but its not enough. I'm very frustrated.

When the vehicle is off i can turn the wheels perfectly by hand.

Any suggestions?

Thank You in advanced

 

[hamz9561]

It sounds like the steering linkage is not centered.

With the linkage disconnected, try turning on the radio with the servo connected to see if it buzzes loudly. A soft hum is okay in a digital servo.

 

[nodsterr]

Thanks for the input, I'm am checking the linkage actually right now.

 

[nodsterr]

Ok that seemed to fix it. But its still making like a buzzing noise like its trying to adjust itself a little iddy bitty pit, then once a poke the steering a little it goes away.....

 

[hotrodrob]

Like hamz said it's normal for a little buzz

 

[SteveM]

Does the 3C allow you to select the frame rate? The 11ms setting works with most digital and analog servos.

 

[ccraig1984]

Steve the dx3c is a non programmable 3 channel.