Hi guys. Pretty new to RC nitro world. My apologies if topic already being talk her. I got an new hyper 7 nitro car. All needle are set to manufacture. However since start 1 car once started after few seconds run full throttle/spinning wheels. Any ideas?
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
Full throttle at start
- Thread starter Michele
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
WickedFog
Starter of too many projects. Oh look... SQUIRREL!
Community Leader
Supporter
Excellence Award
Hospitality Award
Build Thread Contributor
RC Showcase: 9
- Messages
- 28,226
- Reaction score
- 53,131
- Points
- 2,740
- Location
- Terre Haute, IN
- RC Driving Style
- Bashing
- Crawling
- Scale Builder
Welcome to the forum. Can you adjust the idle down?
Tunedfrog
Kermit the frog is a sissy.
Supporter
Excellence Award
Hospitality Award
Military Veteran
Build Thread Contributor
RC Showcase: 10
- Messages
- 17,392
- Reaction score
- 37,845
- Points
- 1,875
- Location
- Idaho
- RC Driving Style
- Bashing
- Crawling
- Scale Builder
tntpoof
Whats Up Doc?
- Messages
- 4,752
- Reaction score
- 2,636
- Points
- 1,060
- Location
- Taylor Michigan
- RC Driving Style
- Bashing
- Racing
- Flying
- Boating
check trim setting on throttle also if you have a th trim dial turn it down...
