Warlock II
RC Newbie
- Messages
- 4
- Reaction score
- 1
I just finished building my first kit, a Capra. I noticed that it runs 100% in reverse, and I can change from 25% to 100% in forward. I'm running a Reedy Radon 16t 5 slot brushed motor, Hobbywing 1080 ESC and a Flysky BS06 receiver with a Flysky GT5 controller. I had to change the controller to reverse so the truck would drive forward when the trigger is pulled back. The ESC has blue and yellow wires that run to the motor, at the ESC the yellow is marked + and the blue is marked -. I hooked them up yellow to red and blue to black, do I need to switch the wires on the motor? Should I change the yellow and blue wire in the connector? Is there something else I should be looking at? Thanks for any help or suggestions.