JP-12
RCTalk Racer
- Messages
- 80
- Reaction score
- 12
It’s probably my fault, hopefully something simple that I’m just looking over, but I’m hoping for advice on what to check for maintenance.
Problems seemed to have started after sitting for a while. I previously upgraded my servos on the bullet, sealed the engine and ran it for a few days with a couple things that were soon sorted out and ran great.
I let the car sit for some time and pulled it back out and was having tons of problems.
The car just wants to take off and will not sit still at idle even with the brake trim fully applied, it will still crawl with the brake applied, but does not seem to rev high.
Any recommendations is much appreciated! I’ve set the needles back to factory and tried to reset them as well with the same results.
Could it be something with the slipper clutch?
Problems seemed to have started after sitting for a while. I previously upgraded my servos on the bullet, sealed the engine and ran it for a few days with a couple things that were soon sorted out and ran great.
I let the car sit for some time and pulled it back out and was having tons of problems.
The car just wants to take off and will not sit still at idle even with the brake trim fully applied, it will still crawl with the brake applied, but does not seem to rev high.
Any recommendations is much appreciated! I’ve set the needles back to factory and tried to reset them as well with the same results.
Could it be something with the slipper clutch?