Brushless motor position on a Traxxas 4-tec

[FaiLasaurus]

I upgraded my 4-tec 3.0 GT4 to a velineon vxl-3s, for the moment I just have the oe pinion(18-t) in it. I could have sworn the brushed motor was in the "B" holes on the mounting plate when I took it apart. This hole is not working for the brushless. Does anyone know where/or if a chart exists, to tell me which hole I should use? I am trying to avoid taking it apart and reassembling it all night. Thanks in advance. Yes this is my very first post on this forum, sorry if this topic is covered somewhere else.

 

[Rob66]

I upgraded my 4-tec 3.0 GT4 to a velineon vxl-3s, for the moment I just have the oe pinion(18-t) in it. I could have sworn the brushed motor was in the "B" holes on the mounting plate when I took it apart. This hole is not working for the brushless. Does anyone know where/or if a chart exists, to tell me which hole I should use? I am trying to avoid taking it apart and reassembling it all night. Thanks in advance. Yes this is my very first post on this forum, sorry if this topic is covered somewhere else.

Here’s the chart.

 

[FaiLasaurus]

Thank you Rob66! I must have been using the wrong words in my searches. Noob problems.