kevhall2
RC Newbie
- Messages
- 6
- Reaction score
- 0
- RC Driving Style
Sorry for the basic question but though I would check before starting to adjust from factory settings when I have no experience.
I have a RTR Hyper 7 black ed (or my son does). Initial start was easy and the idle appeares OK with no forward movement. On the 2nd start It began to have a small amount of pull at idle which increased on the 3rd start to moving fairly slowly with no throttle.
Trimming the throttle made no difference so assume I need to check idle gap is correct (1mm?) and try again. If still hapens adjust low speed needle. Is this correct?
One other clarification please. I've no idea beyond looking at utube as the instructions were none existant. The carb is a slide type but besides the idle screw, appears to have the usual HS and LS adjustmet and what I assume is a third adjustment on the end nearest to the HS adjuster. What is this for please?
Apologies again for the very basic questions and Happy New Year.
Kev.
I have a RTR Hyper 7 black ed (or my son does). Initial start was easy and the idle appeares OK with no forward movement. On the 2nd start It began to have a small amount of pull at idle which increased on the 3rd start to moving fairly slowly with no throttle.
Trimming the throttle made no difference so assume I need to check idle gap is correct (1mm?) and try again. If still hapens adjust low speed needle. Is this correct?
One other clarification please. I've no idea beyond looking at utube as the instructions were none existant. The carb is a slide type but besides the idle screw, appears to have the usual HS and LS adjustmet and what I assume is a third adjustment on the end nearest to the HS adjuster. What is this for please?
Apologies again for the very basic questions and Happy New Year.
Kev.
Last edited: