Bearing Tool Collet

[jv024899]

I acquired a Hudy .12 bearing puller tool, where I was able to push out the 7mm front bearing.

Rear bearing is 12mm, however Hudy doesn't make a collet for 12mm ID bearings. However, Red's makes one.

I'm wondering if the Red's 12mm collet will fit onto the Hudy bearing puller toolset.

I purchased the Red's collet and I will be happy to report back if it works properly. Just want to know if my instincts served me correctly.

 

[monstertruckier15]

If you are trying to remove engine bearings? Good old heat does it cheap.

 

[jv024899]

If you are trying to remove engine bearings? Good old heat does it cheap.

I'm well aware of the technique TY.

Still doesn't answer my question, though.

Cheers!

 

[Greywolf74]

I'm well aware of the technique TY.

Still doesn't answer my question, though.

Cheers!

I'm curious if your experiment worked out or not

 

[jv024899]

I'm curious if your experiment worked out or not

Yes. It was effective. Made life a whole lot easier.

JV

 

[Greywolf74]

Yes. It was effective. Made life a whole lot easier.

JV

Awesome...good to know!

 

[jv024899]

I was mistaken in my original post that the HUDY kit I purchased was for a .21 not a .12.

Anyway, to remove the rear bearing a 12x5mm collet was used to pull the rear. Can confirm it works for the front/rear for the OS21TM engines as well.

I was able to create a little local bearing change/TRX 3.3 engine rebuild side hustle as a result of this.