Bearing Tool Collet

Welcome to RCTalk

Come join other RC enthusiasts! You'll be able to discuss, share and private message with other members of our community.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

jv024899

RCTalk Basher
Messages
70
Reaction score
56
RC Driving Style
  1. Bashing
  2. Racing
I acquired a Hudy .12 bearing puller tool, where I was able to push out the 7mm front bearing.

Rear bearing is 12mm, however Hudy doesn't make a collet for 12mm ID bearings. However, Red's makes one.

I'm wondering if the Red's 12mm collet will fit onto the Hudy bearing puller toolset.

I purchased the Red's collet and I will be happy to report back if it works properly. Just want to know if my instincts served me correctly.
 
If you are trying to remove engine bearings? Good old heat does it cheap.
 
I was mistaken in my original post that the HUDY kit I purchased was for a .21 not a .12.

Anyway, to remove the rear bearing a 12x5mm collet was used to pull the rear. Can confirm it works for the front/rear for the OS21TM engines as well.

I was able to create a little local bearing change/TRX 3.3 engine rebuild side hustle as a result of this.
 
Back
Top