No. It's a 2mm allen on one side. Like these:
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXHFT9&P=7
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXHFT9&P=7
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
Back with another problem!
- Thread starter Austin
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Messages
- 35,104
- Reaction score
- 1,854
- Points
- 2,198
- Location
- In my recliner
- RC Driving Style
- Bashing
- Flying
In the center of the spur gear is a hex nut. Tighten it all the way down, then back it off between 1/8 and 1/4 turn. It might be slightly worn or glazed from too much slipping, so start on the tight side and let us know when you have it up and running again.Austin
RCTalk Basher
- Thread starter
- #24
Ok, Rolex, thanks for the help, I appreciate it, right now i've gotten the entire rear end of my truck torn off, including the engine, and I've finally gotten the rear diff out and there's no chips in it or anything.. refer to my other topic for more info and I would appreciate help VERY much!!