• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

Aluminum hop ups for NTC3???

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

DiegosAnotherR1

RC Newbie
Messages
2
Reaction score
0
Points
0
RC Driving Style
Can you guys help me out? I'm looking for all available aluminum parts for the Nitro TC3(version 2 rear). I want my car to bee all aluminum. Can you guys post the part and where I can get it please? Thanks :cheers:
 
I haven't seen too many aluminum hop ups for the ver 2 rearend. Then again, I only ran that rearend for one race and switched back to the original so I haven't been looking for them. The H arms seemed really weak, IMO.
 
jetmechG550 said:
I haven't seen too many aluminum hop ups for the ver 2 rearend. Then again, I only ran that rearend for one race and switched back to the original so I haven't been looking for them. The H arms seemed really weak, IMO.
So would you say that the version one is a better setup? If it is, what parts would I need to change to version one? Also why would associated change the rear end from version one? Is it cause version 2 has more adjustablity?
 
Version 2 has more adjustablility and the camber adjustment was made differently, it was toe link type setup. FME, I got hit by another car and slapped the wall and it broke the H arm on me. It wasn't a hard hit at all. I wasn't very impressed. Going to a Version 1, you'd have to buy everything individually, I don't know of a kit. I was ver1 and switched back. Parts availability at the time pushed me back to Ver 1 but I do know it's better now. I had read of similar instances too from others.
 
Back
Top