would this work?

[pissant]

i have the mp777 sp1 with the vspec, would this collet fit? http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXDLM9&P=7

 

[pissant]

anybody?

 

[pissant]

would this collet fit the vspec?

 

[ZANDOR]

Do you have a set of cailpers handy
The specs are on there Length: 6.5mm (.257")
Inner Diameter: 7 mm (.275")???

 

[pissant]

why it wont fit, well can somebody help me, what would work for a collet? the kyosho is on back order

 

[ZANDOR]

You need to check the specs on you vspec shaft dia. and the id of your FW...
So do you have a cailper handy?

 

[pissant]

no i dont have one, damn, i need this part so bad!!

 

[ZANDOR]

Well IMO any .21 collet F/w will work with the vspec..

 

[pissant]

ok i will buy it and give it a try

 

[ZANDOR]

Here ace fly wheel and collet
there you go under 20$

 

[ElectriKid3]

I think it might work

 

[pissant]

THANKS ZANDOR!!! i just went and bought it with 2 day shipping, ur the man!

 

[mikeburgin]

pissant, think about it, if all the engines take the same clutch bearings do you think they might all take the same collets???????? the collet is not based aroung your car, its based on your engine, and the diameter of the cracnk is pretty standard between breeds, other wise you would have to buy same brand everything for them.

 

[CorradoPsi]

collet ID's are the same for all big block collets, however, the tapers are different depending on the flywheel. you will just have to order a few collets and find the one that fits best. where is the collet from your vspec?