Why is everything backwards?

[TWOCANE]

My buddy was menning with my stock radieo, now it turns left when I turn to go right. The gas and brake are the same way. You hit the gas and the brake comes on. Heip guys, Wayne:surrender=devil

 

[Rolex]

He flipped the little switches that reverse the servos. Usually on the back of the radio.
Don't let him mess with it any more. If he set your throttle trim all the way up, you could start it and have a runaway. Check EVERYTHING.

 

[brad55102]

Most transmitters have a reverse servo button,,,, Mess with the transmitter and i bet you can fix it.

 

[TWOCANE]

I need to fix it I coould get use to stearing. But not the brake comes on when you gas it. Just flip the channels?

 

[alx]

Yup, its a small switch for each one, throttle and steering

 

[BOUTCH]

The switchs on the Transmitter...flip it.:yes:

 

[Rolex]

They are small switches, usually flush with the case.
If we know what radio you're using, someone will tell you exactly where they are.

 

[TWOCANE]

It is the stock traxxas one TQ3 I believe.

 

[SublimeRevo]

I think I saw the traxxas TQ3 in some of his pictures. The switches are across the bottom of the tx. Flip each one to the opposite position they are in now and you should be all set.

 

[TWOCANE]

thanks... now I might get her dirty.

 

[Zachary]

Radio switches

Okay if your using the traxxas TQ3 radio then the switches are on the bottom. Right by the on/off switch.

All you do is switch it to the opposite side then were it is, and channel one is for steering, two for throttle/brake, and three is for reverse. hope this helps.

 

[ImBroken]

Now go smack him upside his head.....

 

[TWOCANE]

and the red switch doesn't do a thing uniess you have rev, correct?

 

[Zachary]

and the red switch doesn't do a thing uniess you have rev, correct?

The one in the middle of the handle? If so then yes, only for reverse.

 

[joneser4u]

Now go smack him upside his head.....

I second that!:yes:

 

[TWOCANE]

it is all good now, but my OWB froze up.

 

[Rolex]

If you mean it spins freely, then just take it out and clean it, and the shaft, with alcohol.

 

[TWOCANE]

took it out and got it spinning good then put it on and tried starting it and it will not rewind. It did it yesyerday also, so tomorrow I will get a new OWB for it. Also I have the fuel line running like yours on my roll bar hope you dont mind. Also fabed up a cold air intake, I will post up some pics tomorrow after installing the OWB.

 

[Rolex]

Hey, man, I don't have any patents on where I put stuff. If you noticed in my Savage thread, it's been moved under the roll bar where it is far safer from damage.

 

[miketroll357]

I third that, smack him good too!