• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

V-Twin

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
What would be the max temp you guys would run your motors at? Right now both of mine are topping out at 150 degrees running 30c 2s battery's, it seems a bit high to me. I might have to add a couple teeth on the spur but I like where I'm at with the speed. Would a heat sink be beneficial?
Other than that, the truck has been running great! Destroying the body encouraged me to buy a wheelie bar. :hehe:

IMG_1751.gif

IMG_1752.gif

IMG_1753.webp
 
I have a quick question. I am looking for a heat sink for both vellinion motors but I am not sure if it is a 540 or 550 sized can?
 
So jealous, I want to take my 3906 and go brushless on it. How much did both of them cost you?
 
I am in need of some heavy duty springs for the maxx. With two brushless systems and two lipo battery's this thing is pretty heavy. With the springs I have now and 70 weight shock oil, it will bottom out when dropped from knee height. Does any one know of a good spring. I was thinking of using traxxas progressive springs but don't know what the spring rate is.
 
What do you guys think of the new lid? I kept it pretty basic, but I think the stickers make it stand out.:thumbup: Hope you like Ford!
IMG_1800.webp

IMG_1807.webp

IMG_1813.webp

IMG_1802.webp

IMG_1812.webp
 
Back
Top