Upgrading .15 FE?

[olds97_lss]

The pull starter works fine as well. I've run a quart through that engine, but like I said, the previous owner wasn't as kind. When I got it, I tore it down, cleaned it out completely, cleaned the oneway and lubed it. Then I RTV'd it up before I ran it.

Although, I didn't touch the original carb... so it's still filthy.

 

[AC48]

No problem olds. As long as it'll run. Thanks!

 

[olds97_lss]

Yeah, it ran when I took it off and installed my OS 18 that I'm in the process of getting a pipe/header for.

HPI RS4 Nitro MT is the rig I have.

 

[AC48]

Okay sounds good olds, thanks!

 

[rossb]

The pipe is the HPI Polished tuned pipe for the savage, it came with my SS 4.6 kit.

Why are you selling the Polished Dual Chamber Pipe? I just put this pipe on my Picco 26 and I like it.

 

[olds97_lss]

He said he has a c-vec pipe that he's currently using and apparently likes it better. The polished pipe is used.

 

[rossb]

I just built an RS4 18ss and I am probably going to replace the stock pipe and header with a THS setup. Motor has not even been started yet. If you need a header & a pipe make me an offer.

 

[AC48]

Yeah, the CVEC pipe I have is much quieter and has similar performance as the Polished HPI.

 

[AC48]

olds, you have PM.

 

[olds97_lss]

I just built an RS4 18ss and I am probably going to replace the stock pipe and header with a THS setup. Motor has not even been started yet. If you need a header & a pipe make me an offer.

Crap... I just bought a header off one guy and a associated pipe off another guy.

Oh well. Still cheaper than tower. $20 shipped vs $32 shipped.