uhOH i may have adj. the msn screw on my hyper !

[Mr.Pink]

I have a 4port hyper21 engine on my K2 . I am new to this so forgive me . I was readingthe ofna site about tuning and it said DON"T ADJUST THE MSN ( midrange needle screw ) . I turned it about a 1/4 turn and then back again . Is that really bad ? What if it is not in the exact same spot ? It may be off by like a 1/16th of a inch. What shouldi do ? The car seems to run fine . Starts really fast , I am just in the middle of tuning the hsn and lsn to get best temps and acceleration .

 

[Plaidfish]

now you've done it your car is dead.....no more play time for you....

 

[Plaidfish]

you should be fine

 

[mikeburgin]

all the mid needle does is changes the tiing from lsn to your hsn, just meants it will hold on to the low end or come on to the high end needles ealier or later, no probs specially in that smaller amount

 

[Buggyracer28]

OHHH MMMYYY GGGGODDD!!!!! If you adjust something at how ever many turns, and then turn it back, its gonna be the same.... and if you do turn a needle 1/4 turn, who cares? its a tiny increment.... just turn it back. Welcome to the world of tuning engines lol.