Has it been done before? also I'm making a 3d design for a extra 2”+ in the rear
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
Traxxas Slash 2wd LWB Coversion
- Thread starter Addict Rc
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Messages
- 1,890
- Reaction score
- 3,247
- Points
- 545
- Location
- Harris County, Texas
- RC Driving Style
- Bashing
- Racing
Seen a LWB Bandit or two. Slash is doable. Consider matching extended w/b to a readily available aftermarket body. Saves a lot of heartburn at project's end when it comes time to fit a body.
I once built a chassis to fit an existing body. Once was enough.
Good luck, Addict. 'AC'
I once built a chassis to fit an existing body. Once was enough.
Good luck, Addict. 'AC'
