Tmaxx96
Gone - bye bye.
my tmaxx 2.5 was sitting for at least 5 months should i clean out my carb and if i do what do i use?
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
Tmaxx Carburator
- Thread starter Tmaxx96
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
hpiracing1123
RCTalk Talkaholic
if anything just rebuild it
Might be a good idea to take it all apart and soak the carb body/slide in some DA (denatured alcohol) for a little bit and clean out all the cracks/creases with a q-tip. Be carful to not get DA on the o-rings. At least don't let the o-rings soak in DA.
It would also be a good idea to clean the crank case area where the carb goes with some DA and seal it with RTV when you put it back together. You can pick that stuff up and nearly any autoparts store for a few $.
It would also be a good idea to clean the crank case area where the carb goes with some DA and seal it with RTV when you put it back together. You can pick that stuff up and nearly any autoparts store for a few $.
I'd try to run it first, 5 months isn't bad.
brad55102
RCTalk Addict
Is there a carb rebuild kit?