Thunder tiger panda 2 fuel inlet nipple

[no_one]

Hey guys, i am trying to find a suitable fuel inlet nipple for a Thunder tiger panda 2, as i broke the previous one during assembly. it has a thunder tiger gp-15 motor with the original carb, and if i remember correctly the inner diameter of the fuel inlet was 5mm.
Would appreciate any help.

 

[WickedFog]

Got a picture of the broken nipple?

 

[no_one]

Got a picture of the broken nipple?

Wasn't sure i still had it, but i had a dig around in my old projects corner and surprisingly i still do! I had also misremembered, the inner diameter is 4mm

 

[Greywolf74]

Have you been looking for one of these for awhile?

https://www.rctech.net/forum/offroad-nitro-engine-forum/1077526-broken-carb-fuel-inlet.html

 

[tudordewolf]

You could try a carb swap, or maybe see if the inlet from this Sh.18 carb is compatible

 

[Greywolf74]

@WickedFog looked around on the interwebz for one since banjo fittings are an industry part but the commercially available ones dont seem to come in sizes less than 5mm ID. I think he forgot to post that yesterday.

 

[no_one]

Haha i think you might be right, i hadn't touched the thing since i moved a while ago

Have you been looking for one of these for awhile?

https://www.rctech.net/forum/offroad-nitro-engine-forum/1077526-broken-carb-fuel-inlet.html

.

@WickedFog looked around on the interwebz for one since banjo fittings are an industry part but the commercially available ones dont seem to come in sizes less than 5mm ID. I think he forgot to post that yesterday.

Yeah, sadly i came to the same conclusion, been emailing a bunch of rc shops, but sadly just haven't found the right sized fitting yet :'(