this stinks

[raaazzzeee]

after 1 1/2 hours of dremaling a slot in the to striped screws that hold on my engine, i got the engine off and put the new pull start on. I drove it for a little while, got the engine adjusted almost perfect when i went to pull start it again and the pull was no where to be found, i found it in the grass, and relized that it had gotton caught under the wheel. So should i take it back? or try to fix it?

 

[4u2nv]

I highly doubt theyd take it back.. Welcome to the world of pullstarts.

 

[HeartBreak]

Ouch, I've never seen or heard of that happening. You were running without the body, eh? You can probably shorten the plastic tube that holds the handle up-off of the pullstart casing, so it'll sit lower down in the model.

 

[retarded pilot]

i had that happen on a nitro sport once, no one will take that back. you will just have to buy a new one...