Thinking about gong brushless

[Tallbump]

Ok, I think I want to pull the trigger and go brushless on one of my crawlers. I keep reading about the Furtiek Kimodo/Lizard Pro set up.

But then IGOUPRC 2204 2400KV Brushless Outrunner Motor with Transmission & 30A Brushless Mini Esc recently have been reading about the GOUPRC 2204 2400KV Brushless Outrunner Motor with Transmission & 30A Brushless Mini Esc - https://www.amazon.com/gp/product/B0DNMGMTFC/ref=ox_sc_act_title_1?smid=A2DMYLKCSA4EM3&th=1

What I am trying to figure out is can I use my factory ESC as the receiver and keep my controller, or do I need to replace those, too?

I am still fairly new to this and some of it is making sense, and some just leads to more questions

 

[Mrgoodwrench35]

It might help to include information on what crawler your working on.

From what I've seen, if you have a 2 in 1 esc/receiver combo, you have to get a new stand alone receiver if you go to a stand alone esc.

 

[Tallbump]

I'm looking to put it in this - https://www.rctalk.com/forum/showcase/the-yeti.262/

 

[nino]

If I remember right, there was a way to chop off the Rx part off the combo. But they did a few updates on the electronics so not sure anymore.

Btw... THIS is a Yeti:

Edit: a SLT protocol rx should work. The info online ain't exactly clear.