The RB10 strikes again!

[Cheetah928]

Hello everyone! Got the RB10 back up and running with upgraded front suspension arms. Bought a new set of tires as well but when I had them on, the car stripped out the rear right tire! The hole where the hex goes got completely stripped, even after I made sure it was tight! Anyone know why?

 

[9x19]

Slipper too tight and drive torque rounded out the wheel hex instead?

 

[RustyUs]

Are you using the stock flanged serrated wheel nuts? They are decent, but you gotta crank them down for the serrations to grab hold of the wheel. Also, if you are using the composite hex adaptors, you may want to switch to aluminum clamping type as they will hold up to abuse better... provided the wheel nuts are tightened.

 

[RustyUs]

Can you reuse rounded wheels and hexes pt1

 

[CertifiedMike]

Are you using the stock flanged serrated wheel nuts? They are decent, but you gotta crank them down for the serrations to grab hold of the wheel. Also, if you are using the composite hex adaptors, you may want to switch to aluminum clamping type as they will hold up to abuse better... provided the wheel nuts are tightened.

X's 2!