T maxx 3.3 driveshafts

[R-morris29]

I was looking into getting steel drive shafts for my t maxx didn't know what was was the best to go with? I was thinking mip but they seem heavy?

 

[hotrodrob]

Well all cvd are heavy comparibly givin that they're steel, the mip are a good set

 

[scootr]

Are they for a 4908/4907 model?

 

[savage24x]

Definitely MIP.

 

[R-morris29]

It's a 4907 model without reverse

 

[hulkmaxx]

RC best make a set for the #4907 maxx. I have had great luck with there drive shafts in the past, there a little cheaper than the MIP ones to.

 

[Bill]

Whats the overall benefit of steel shafts vs. OEM?

 

[JAMMER]

Never had any trouble with my MIP shafts just a little grease in the cups helps a long ways.

 

[olds97_lss]

Whats the overall benefit of steel shafts vs. OEM?

Strength. Can handle more power. May last a while longer as well from normal wear.

 

[Bill]

Strength. Can handle more power. May last a while longer as well from normal wear.

Got ya! Would you suggest going with all steel shafts or just the center steel CV's?

 

[olds97_lss]

If your running the stock engine, then stock shafts work fine. The 3.3 sliders are similar to the sliders on the revo and I run a big block in one of my revos with stock axles without much issue. I just keep an eye on the yokes and as they wear out, I get a new set on order from ebay.