steering question

[SewerBeing]

I have a HPI rs4 3 evo and I've noticed that it doesn't quite go straight (its not a major effect so if I turn a lot I don't notice too much). However I already have the steering trim at its maximum and it still seems to do it. I was wondering if there was an easy way to adjust the 0 position of the servo. Thank you!

 

[Rolex]

Disconnect the servo arm from the servo. Turn on the Tx and Rx and center the trim knob. Visibly straighten the wheels and reinstall the servo arm. You're good to go.

 

[MustangMan]

Exactly what Rolex says, and if it is still just a hair off you have two options, the turnbuckle on the steering linkage or the servo trim on the transmitter...

 

[Foolproof]

+1 to both.