steering problem

[nitro_freak_123]

hey guys I've run into a bit of a problem with my steering i need some advice of what to do



right i crashed into a curb recently and ever since that happened my truck has been pulling to the right and its annoying me


is there anything i can adjust to make it right i recenlty took it apart could'nt see any damage.

when i drive my truck sometimes the steering servo sticks in 1 place this aint normal right


this is my servo : the black futaba 1

can i adjust these (marked in yellow)
if so how ? would they make any difference i i adjusted them ?

thanks nitro freak:fro: :fro:

 

[jetmechG550]

Yes you can adjust those, or at least you can on most cars. You probably knocked the toe banging the curb. It's a little hard to see in the px but they should be a threaded rod so just loosen one of you rod ends up and adjust accordingly. As far the servo sticking, no not normal. I can't tell what rig that is but does it have a servo saver? You may have lost a couple teeth on the internal gears on the servo

 

[nitro_freak_123]

the servo a new 1 bought it after crash its a thunder tiger ssk v1 4wd

yes they are threaded i how i loosen them ???? thanks

 

[Monkey Wrench]

Turn them, probably counterclockwise.

 

[nitro_freak_123]

ill try that tomorrow mokey thanks if still problems what else shall i try ???????????????????????

 

[Plaidfish]

just remember one side is a lefty thread...

 

[godale03]

just remember one side is a lefty thread...

I hate turnbuckles.... That reverse threading gets me every time! LOL

Tom