• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

stalling savage

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

NITROMITE

Gone - bye bye.
Messages
151
Reaction score
0
Points
0
Location
pataskala, ohio
RC Driving Style
  1. Bashing
my savage 21 is ideling great but stalls when i hit the gas plus alot of fule is spiting from the pipe help:D

help my savage is ideling fine but stalls and spits alot of fule can any one help
 
Lean the LSN 1/8 of a turn in. It should improve. Make a couple of runs with it to blow out the excess fuel. If you're noticing an improvement but still not getting good punch off the line, lean it by another 1/16, and again, make a couple of runs before doing anything else. The LSN is for starting punch, and up to about 1/3 throttle. Beyond that, any adjustments will be on the HSN.
 
Also if it dies when you apply the brakes, you may need to turn the idle screw in.
Pull the air filter, you should have a 1 mm gap between the carb slide and carb neck.
The throttle slide should not move when you go from idle to brake position on the transmitter.
 
Back
Top