ST-R has arrived

[robmob]

Could not get a grip on the flywheel. Screwdriver was useless in doing it as well. It was just easier to take the mill out than fight with it any further. When it gets stuck, it is locked in tight.

If anyone has tricks to unlock the piston while it is still mounted, I am open to try anything.

 

[jon2]

Did you try to reheat the head again?

 

[robmob]

Oh Snap. I didn't think to heat the block to unstick the piston LMAO. I had the hair dryer sitting right there too.

 

[jon2]

Oh Snap. I didn't think to heat the block to unstick the piston LMAO. I had the hair dryer sitting right there too.

I know this only because my P5X was a PITA to break in.Even now it is still a PITA.