Spektrum NX6 DLG setup issues

[davidfloegel]

Hi!

After years of using multiplex I’ve switched to Spektrum NX6 today.

I bought a 4 channel receiver (AR410) with it and am trying to set up a DLG with 2 aileron servos, elevator and rudder. I’ve selected the correct mode type and wing type as well.

My servos are plugged in as follows:
1: left aileron
2: right aileron
3: rudder
4: elevator

Elevator and rudder work well, for some reason though, I can’t get the 2nd aileron servo to mix with the other one.

One confusion: The channel 1 shows “throttle” and I can’t assign ailerons to that which seems not quite right? The second aileron is assigned to AUX1 which is channel 6, obviously that doesn’t exist on my 4 channel receiver.

Anyone able to give me a hand?

Best wishes!

 

[tntpoof]

switch back to multiplex..
I'm not a fan of spektrum,not all work with as stated by spek.id switch models.this sounds like a none powered glider or sailplane

 

[mikekehrli]

Hi!

After years of using multiplex I’ve switched to Spektrum NX6 today.

I bought a 4 channel receiver (AR410) with it and am trying to set up a DLG with 2 aileron servos, elevator and rudder. I’ve selected the correct mode type and wing type as well.

My servos are plugged in as follows:
1: left aileron
2: right aileron
3: rudder
4: elevator

Elevator and rudder work well, for some reason though, I can’t get the 2nd aileron servo to mix with the other one.

One confusion: The channel 1 shows “throttle” and I can’t assign ailerons to that which seems not quite right? The second aileron is assigned to AUX1 which is channel 6, obviously that doesn’t exist on my 4 channel receiver.

Anyone able to give me a hand?

Best wishes!

I have 2 planes with Spektrum receivers. In both cases the ailerons are on the same channel. I have a splitter that joins the servos to one connector and that plugs into channel 2. For my setup 1 is throttle, 2 is ailerons (both), 3 is Elevator and 4 is rudder. I can't imagine needing to control ailerons separately.